TMA-CHECKPOINT-2.2.4
Ensure SNMP traps receivers is set
OrtaDüzey 1Otomatikcheckpoint
Açıklama
Enables SNMP traps receivers where traps to be sent to. PASS requires an SNMPv3 trap receiver. Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).
Nasıl denetlenir
Denetim yöntemi: Yapılandırma deseni
- Desen
(?m)^add snmp traps receiver \S+ version v3\b
Nasıl düzeltilir
Düzeltme yöntemi: Kılavuz veya altyapı yaması
add snmp traps receiver 10.10.168.86 version v3 save config # CIS guidance: Run the following command to Configure the SNMP traps receivers. CLI: add snmp traps receiver 10.10.168.86 version v3 GUI: Navigate to System Management > SNMP > Trap Receivers Setting > Add > Add IP Address Version details.
Özellikler
- İşletim sistemleri
- Herhangi biri
- Etiketler
- checkpointsnmp
- Referans
- CIS Check Point Firewall Benchmark v1.1.0 - 2.2.4 Ensure SNMP traps receivers is set
Bu ana makineyi denetle
Bunu denetleme izniniz olan bir makinede çalıştırın. Tarama salt okunurdur.
shell
tmaegis scan --target checkpoint