TMA-CHECKPOINT-2.2.4
Ensure SNMP traps receivers is set
Beschreibung
Enables SNMP traps receivers where traps to be sent to. PASS requires an SNMPv3 trap receiver. Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).
So wird geprüft
Prüfmethode: Konfigurationsmuster
- Muster
(?m)^add snmp traps receiver \S+ version v3\b
So wird behoben
Behebungsmethode: Anleitung oder Infrastruktur-Patch
add snmp traps receiver 10.10.168.86 version v3 save config # CIS guidance: Run the following command to Configure the SNMP traps receivers. CLI: add snmp traps receiver 10.10.168.86 version v3 GUI: Navigate to System Management > SNMP > Trap Receivers Setting > Add > Add IP Address Version details.
Eigenschaften
- Betriebssysteme
- Beliebig
- Tags
- checkpointsnmp
- Referenz
- CIS Check Point Firewall Benchmark v1.1.0 - 2.2.4 Ensure SNMP traps receivers is set
Diesen Host prüfen
Führen Sie dies auf einem Rechner aus, den Sie prüfen dürfen. Der Scan ist schreibgeschützt.
tmaegis scan --target checkpoint