Ensure SNMP traps is enabled

中级别 1自动化checkpoint

说明

Enables SNMP traps to be sent to the NMS. PASS requires the authorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace traps enabled (matched in the alphabetical order clish prints them). Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

检查方式

审计方法: 配置正则匹配

匹配模式: (?ms)^set snmp traps trap authorizationError enable.*?^set snmp traps trap coldStart enable.*?^set snmp traps trap configurationChange enable.*?^set snmp traps trap configurationSave enable.*?^set snmp traps trap linkUpLinkDown enable.*?^set snmp traps trap lowDiskSpace enable

修复方式

修复方法: 操作指南或基础设施补丁

set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable save config # CIS guidance: Run the following command to Configure the SNMP traps. CLI: set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable GUI: Navigate to System Management > SNMP > Enabled Traps > Set and select the following traps uthorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace

属性

操作系统: 任意
标签: checkpointsnmp
参考: CIS Check Point Firewall Benchmark v1.1.0 - 2.2.3 Ensure SNMP traps is enabled

检查本机

请在您有权审计的机器上运行此命令。扫描为只读操作。

shell

tmaegis scan --target checkpoint