TMA-CHECKPOINT-2.2.3

Ensure SNMP traps is enabled

中レベル 1自動checkpoint

説明

Enables SNMP traps to be sent to the NMS. PASS requires the authorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace traps enabled (matched in the alphabetical order clish prints them). Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

チェック方法

監査方法: 設定パターン

パターン: (?ms)^set snmp traps trap authorizationError enable.*?^set snmp traps trap coldStart enable.*?^set snmp traps trap configurationChange enable.*?^set snmp traps trap configurationSave enable.*?^set snmp traps trap linkUpLinkDown enable.*?^set snmp traps trap lowDiskSpace enable

修正方法

修正方法: ガイダンスまたは IaC パッチ

set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable save config # CIS guidance: Run the following command to Configure the SNMP traps. CLI: set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable GUI: Navigate to System Management > SNMP > Enabled Traps > Set and select the following traps uthorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace

プロパティ

オペレーティングシステム: すべて
タグ: checkpointsnmp
参照: CIS Check Point Firewall Benchmark v1.1.0 - 2.2.3 Ensure SNMP traps is enabled

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target checkpoint