TMA-CHECKPOINT-2.2.3
Ensure SNMP traps is enabled
Beschreibung
Enables SNMP traps to be sent to the NMS. PASS requires the authorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace traps enabled (matched in the alphabetical order clish prints them). Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).
So wird geprüft
Prüfmethode: Konfigurationsmuster
- Muster
(?ms)^set snmp traps trap authorizationError enable.*?^set snmp traps trap coldStart enable.*?^set snmp traps trap configurationChange enable.*?^set snmp traps trap configurationSave enable.*?^set snmp traps trap linkUpLinkDown enable.*?^set snmp traps trap lowDiskSpace enable
So wird behoben
Behebungsmethode: Anleitung oder Infrastruktur-Patch
set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable save config # CIS guidance: Run the following command to Configure the SNMP traps. CLI: set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable GUI: Navigate to System Management > SNMP > Enabled Traps > Set and select the following traps uthorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace
Eigenschaften
- Betriebssysteme
- Beliebig
- Tags
- checkpointsnmp
- Referenz
- CIS Check Point Firewall Benchmark v1.1.0 - 2.2.3 Ensure SNMP traps is enabled
Diesen Host prüfen
Führen Sie dies auf einem Rechner aus, den Sie prüfen dürfen. Der Scan ist schreibgeschützt.
tmaegis scan --target checkpoint