TMA-CHECKPOINT-2.2.3
Ensure SNMP traps is enabled
Опис
Enables SNMP traps to be sent to the NMS. PASS requires the authorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace traps enabled (matched in the alphabetical order clish prints them). Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).
Како се проверава
Метод провере: Образац конфигурације
- Образац
(?ms)^set snmp traps trap authorizationError enable.*?^set snmp traps trap coldStart enable.*?^set snmp traps trap configurationChange enable.*?^set snmp traps trap configurationSave enable.*?^set snmp traps trap linkUpLinkDown enable.*?^set snmp traps trap lowDiskSpace enable
Како се исправља
Метод исправке: Смерница или закрпа инфраструктуре
set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable save config # CIS guidance: Run the following command to Configure the SNMP traps. CLI: set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable GUI: Navigate to System Management > SNMP > Enabled Traps > Set and select the following traps uthorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace
Својства
- Оперативни системи
- Било који
- Ознаке
- checkpointsnmp
- Референца
- CIS Check Point Firewall Benchmark v1.1.0 - 2.2.3 Ensure SNMP traps is enabled
Проверите овај рачунар
Покрените ово на рачунару за који имате дозволу за проверу. Скенирање ради у режиму само за читање.
tmaegis scan --target checkpoint