TMA-CHECKPOINT-2.2.3

Ensure SNMP traps is enabled

보통레벨 1자동checkpoint

설명

Enables SNMP traps to be sent to the NMS. PASS requires the authorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace traps enabled (matched in the alphabetical order clish prints them). Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

점검 방법

감사 방식: 구성 패턴

패턴: (?ms)^set snmp traps trap authorizationError enable.*?^set snmp traps trap coldStart enable.*?^set snmp traps trap configurationChange enable.*?^set snmp traps trap configurationSave enable.*?^set snmp traps trap linkUpLinkDown enable.*?^set snmp traps trap lowDiskSpace enable

조치 방법

조치 방식: 가이드 또는 인프라 패치

set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable save config # CIS guidance: Run the following command to Configure the SNMP traps. CLI: set snmp traps trap authorizationError enable set snmp traps trap coldStart enable set snmp traps trap configurationChange enable set snmp traps trap configurationSave enable set snmp traps trap linkUpLinkDown enable set snmp traps trap lowDiskSpace enable GUI: Navigate to System Management > SNMP > Enabled Traps > Set and select the following traps uthorizationError, coldStart, configurationChange, configurationSave, linkUpLinkDown and lowDiskSpace

속성

운영 체제: 모두
태그: checkpointsnmp
참고 자료: CIS Check Point Firewall Benchmark v1.1.0 - 2.2.3 Ensure SNMP traps is enabled

이 호스트 점검하기

감사 권한이 있는 시스템에서 실행하세요. 스캔은 읽기 전용입니다.

shell

tmaegis scan --target checkpoint