Ensure Reverse Path Filtering is enabled

中等級 1自動化linux

說明

Setting net.ipv4.conf.all.rp_filterand net.ipv4.conf.default.rp_filter to 1 forces the Linux kernel to utilize reverse path filtering on a received packet to determine if the packet was valid. Essentially, with reverse path filtering, if the return packet does not go out the same interface that the corresponding source packet came from, the packet is dropped (and logged if log_martians is set).

檢查方式

稽核方法: Shell 指令

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.rp_filter 1 && chk net.ipv4.conf.default.rp_filter 1; then echo compliant; fi

預期輸出: compliant

修補方式

修補方法: 操作指南或基礎設施修補檔

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.rp_filter = 1 net.ipv4.conf.default.rp_filter = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.rp_filter=1 # sysctl -w net.ipv4.conf.default.rp_filter=1 # sysctl -w net.ipv4.route.flush=1

屬性

作業系統: alinux-2
標籤: cis-convertedkernellinuxsysctl
參考資料: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.7

檢查此主機

請在您有權稽核的機器上執行此指令。掃描為唯讀操作。

shell

tmaegis scan --target linux