Ensure Reverse Path Filtering is enabled

中レベル 1自動linux

説明

Setting net.ipv4.conf.all.rp_filterand net.ipv4.conf.default.rp_filter to 1 forces the Linux kernel to utilize reverse path filtering on a received packet to determine if the packet was valid. Essentially, with reverse path filtering, if the return packet does not go out the same interface that the corresponding source packet came from, the packet is dropped (and logged if log_martians is set).

チェック方法

監査方法: シェルコマンド

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.rp_filter 1 && chk net.ipv4.conf.default.rp_filter 1; then echo compliant; fi

期待される出力: compliant

修正方法

修正方法: ガイダンスまたは IaC パッチ

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.rp_filter = 1 net.ipv4.conf.default.rp_filter = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.rp_filter=1 # sysctl -w net.ipv4.conf.default.rp_filter=1 # sysctl -w net.ipv4.route.flush=1

プロパティ

オペレーティングシステム: alinux-2
タグ: cis-convertedkernellinuxsysctl
参照: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.7

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target linux