Ensure Reverse Path Filtering is enabled

MittelStufe 1Automatisiertlinux

Beschreibung

Setting net.ipv4.conf.all.rp_filterand net.ipv4.conf.default.rp_filter to 1 forces the Linux kernel to utilize reverse path filtering on a received packet to determine if the packet was valid. Essentially, with reverse path filtering, if the return packet does not go out the same interface that the corresponding source packet came from, the packet is dropped (and logged if log_martians is set).

So wird geprüft

Prüfmethode: Shell-Befehl

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.rp_filter 1 && chk net.ipv4.conf.default.rp_filter 1; then echo compliant; fi

Erwartete Ausgabe: compliant

So wird behoben

Behebungsmethode: Anleitung oder Infrastruktur-Patch

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.rp_filter = 1 net.ipv4.conf.default.rp_filter = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.rp_filter=1 # sysctl -w net.ipv4.conf.default.rp_filter=1 # sysctl -w net.ipv4.route.flush=1

Eigenschaften

Betriebssysteme: alinux-2
Tags: cis-convertedkernellinuxsysctl
Referenz: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.7

Diesen Host prüfen

Führen Sie dies auf einem Rechner aus, den Sie prüfen dürfen. Der Scan ist schreibgeschützt.

shell

tmaegis scan --target linux