Ensure Reverse Path Filtering is enabled

MediaNivel 1Automatizadalinux

Descripción

Setting net.ipv4.conf.all.rp_filterand net.ipv4.conf.default.rp_filter to 1 forces the Linux kernel to utilize reverse path filtering on a received packet to determine if the packet was valid. Essentially, with reverse path filtering, if the return packet does not go out the same interface that the corresponding source packet came from, the packet is dropped (and logged if log_martians is set).

Cómo se verifica

Método de auditoría: Comando de shell

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.rp_filter 1 && chk net.ipv4.conf.default.rp_filter 1; then echo compliant; fi

Salida esperada: compliant

Cómo se corrige

Método de corrección: Guía o parche de infraestructura

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.rp_filter = 1 net.ipv4.conf.default.rp_filter = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.rp_filter=1 # sysctl -w net.ipv4.conf.default.rp_filter=1 # sysctl -w net.ipv4.route.flush=1

Propiedades

Sistemas operativos: alinux-2
Etiquetas: cis-convertedkernellinuxsysctl
Referencia: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.7

Verificar este host

Ejecute esto en un equipo que tenga permiso para auditar. El escaneo es de solo lectura.

shell

tmaegis scan --target linux