Ensure source routed packets are not accepted

中等級 1自動化linux

說明

In networking, source routing allows a sender to partially or fully specify the route packets take through a network. In contrast, non-source routed packets travel a path determined by routers in the network. In some cases, systems may not be routable or reachable from some locations (e.g. private addresses vs. Internet routable), and so source routed packets would need to be used.

檢查方式

稽核方法: Shell 指令

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.accept_source_route 0 && chk net.ipv4.conf.default.accept_source_route 0 && chk net.ipv6.conf.all.accept_source_route 0 && chk net.ipv6.conf.default.accept_source_route 0; then echo compliant; fi

預期輸出: compliant

修補方式

修補方法: 操作指南或基礎設施修補檔

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.accept_source_route = 0 net.ipv4.conf.default.accept_source_route = 0 net.ipv6.conf.all.accept_source_route = 0 net.ipv6.conf.default.accept_source_route = 0 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.accept_source_route=0 # sysctl -w net.ipv4.conf.default.accept_source_route=0 # sysctl -w net.ipv6.conf.all.accept_source_route=0 # sysctl -w net.ipv6.conf.default.accept_source_route=0 # sysctl -w net.ipv4.route.flush=1 # sysctl -w net.ipv6.route.flush=1

屬性

作業系統: alinux-2
標籤: cis-convertedkernellinuxsysctl
參考資料: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.1

檢查此主機

請在您有權稽核的機器上執行此指令。掃描為唯讀操作。

shell

tmaegis scan --target linux