Ensure source routed packets are not accepted

中レベル 1自動linux

説明

In networking, source routing allows a sender to partially or fully specify the route packets take through a network. In contrast, non-source routed packets travel a path determined by routers in the network. In some cases, systems may not be routable or reachable from some locations (e.g. private addresses vs. Internet routable), and so source routed packets would need to be used.

チェック方法

監査方法: シェルコマンド

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.accept_source_route 0 && chk net.ipv4.conf.default.accept_source_route 0 && chk net.ipv6.conf.all.accept_source_route 0 && chk net.ipv6.conf.default.accept_source_route 0; then echo compliant; fi

期待される出力: compliant

修正方法

修正方法: ガイダンスまたは IaC パッチ

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.accept_source_route = 0 net.ipv4.conf.default.accept_source_route = 0 net.ipv6.conf.all.accept_source_route = 0 net.ipv6.conf.default.accept_source_route = 0 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.accept_source_route=0 # sysctl -w net.ipv4.conf.default.accept_source_route=0 # sysctl -w net.ipv6.conf.all.accept_source_route=0 # sysctl -w net.ipv6.conf.default.accept_source_route=0 # sysctl -w net.ipv4.route.flush=1 # sysctl -w net.ipv6.route.flush=1

プロパティ

オペレーティングシステム: alinux-2
タグ: cis-convertedkernellinuxsysctl
参照: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.1

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target linux