Ensure source routed packets are not accepted

SrednjaNivo 1Automatskalinux

Opis

In networking, source routing allows a sender to partially or fully specify the route packets take through a network. In contrast, non-source routed packets travel a path determined by routers in the network. In some cases, systems may not be routable or reachable from some locations (e.g. private addresses vs. Internet routable), and so source routed packets would need to be used.

Kako se proverava

Metod provere: Komanda ljuske

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.accept_source_route 0 && chk net.ipv4.conf.default.accept_source_route 0 && chk net.ipv6.conf.all.accept_source_route 0 && chk net.ipv6.conf.default.accept_source_route 0; then echo compliant; fi

Očekivani izlaz: compliant

Kako se ispravlja

Metod ispravke: Smernica ili zakrpa infrastrukture

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.accept_source_route = 0 net.ipv4.conf.default.accept_source_route = 0 net.ipv6.conf.all.accept_source_route = 0 net.ipv6.conf.default.accept_source_route = 0 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.accept_source_route=0 # sysctl -w net.ipv4.conf.default.accept_source_route=0 # sysctl -w net.ipv6.conf.all.accept_source_route=0 # sysctl -w net.ipv6.conf.default.accept_source_route=0 # sysctl -w net.ipv4.route.flush=1 # sysctl -w net.ipv6.route.flush=1

Svojstva

Operativni sistemi: alinux-2
Oznake: cis-convertedkernellinuxsysctl
Referenca: CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.1

Proverite ovaj računar

Pokrenite ovo na računaru za koji imate dozvolu za proveru. Skeniranje radi u režimu samo za čitanje.

shell

tmaegis scan --target linux