TMAegisBeta
Više pravila za linux

Linux distributions

TMA-ALINUX2-3.2.8

Ensure TCP SYN Cookies is enabled

SrednjaNivo 1Automatskalinux

Opis

When tcp_syncookies is set, the kernel will handle TCP SYN packets normally until the half-open connection queue is full, at which time, the SYN cookie functionality kicks in. SYN cookies work by not using the SYN queue at all. Instead, the kernel simply replies to the SYN with a SYN|ACK, but will include a specially crafted TCP sequence number that encodes the source and destination IP address and port number and the time the packet was sent. A legitimate connection would send the ACK packet of the three way handshake with the specially crafted sequence number. This allows the system to verif

Kako se proverava

Metod provere: Komanda ljuske

shell
chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.tcp_syncookies 1; then echo compliant; fi
Očekivani izlaz
compliant

Kako se ispravlja

Metod ispravke: Smernica ili zakrpa infrastrukture

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.tcp_syncookies = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.tcp_syncookies=1 # sysctl -w net.ipv4.route.flush=1

Svojstva

Operativni sistemi
alinux-2
Oznake
cis-convertedkernellinuxsysctl
Referenca
CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.8

Proverite ovaj računar

Pokrenite ovo na računaru za koji imate dozvolu za proveru. Skeniranje radi u režimu samo za čitanje.

shell
tmaegis scan --target linux