TMAegis
Другие правила для linux

Linux distributions

TMA-ALINUX2-3.2.8

Ensure TCP SYN Cookies is enabled

СреднийУровень 1Автоматическаяlinux

Описание

When tcp_syncookies is set, the kernel will handle TCP SYN packets normally until the half-open connection queue is full, at which time, the SYN cookie functionality kicks in. SYN cookies work by not using the SYN queue at all. Instead, the kernel simply replies to the SYN with a SYN|ACK, but will include a specially crafted TCP sequence number that encodes the source and destination IP address and port number and the time the packet was sent. A legitimate connection would send the ACK packet of the three way handshake with the specially crafted sequence number. This allows the system to verif

Как проверяется

Метод проверки: Команда оболочки

shell
chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.tcp_syncookies 1; then echo compliant; fi
Ожидаемый вывод
compliant

Как исправляется

Метод исправления: Рекомендация или патч инфраструктуры

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.tcp_syncookies = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.tcp_syncookies=1 # sysctl -w net.ipv4.route.flush=1

Свойства

Операционные системы
alinux-2
Теги
cis-convertedkernellinuxsysctl
Источник
CIS Aliyun Linux 2 Benchmark v1.0.0 ARCHIVE - 3.2.8

Проверить этот хост

Выполните команду на компьютере, аудит которого вам разрешён. Сканирование работает только на чтение.

shell
tmaegis scan --target linux