Ensure default Admin ports are changed

Trung bìnhCấp 1Tự độngfortiswitch

Mô tả

FortiSwitch admin ports listen on the common ports of 80 and 443. This is default behavior. While interface access is controlled by configuring network interfaces, the FortiSwitch still listens on the admin ports that have been configured, which can also cause a conflict should 80 or 443 be needed as part of additional configuration later on. FAILs if the SSH admin port is still 22 or the HTTPS admin port is still 443. Audited against FortiSwitchOS 'show full-configuration' output (standalone FortiSwitch, saved in full); patterns are scoped to the named 'config ... end' block, whose member lines are indented.

Cách kiểm tra

Phương pháp kiểm tra: Mẫu cấu hình

Mẫu khớp: (?m)(?:^config system global\n(?:[ \t]+[^\n]*\n)*?[ \t]+set admin-ssh-port 22[ \t]*$|^config system web\n(?:[ \t]+[^\n]*\n)*?[ \t]+set https-port 443[ \t]*$)

Cách khắc phục

Phương pháp khắc phục: Hướng dẫn hoặc bản vá hạ tầng

config system global set admin-ssh-port 4422 end config system web set https-port 4443 end # CIS guidance: CLI for changing SSH port: config system global set admin-ssh-port 4422 **(or any other uncommon port)** end CLI for changing HTTPS port: config system web set https-port 4443 **(or any other uncommon port)** end OR From Web GUI: 1. System > Admin > Settings 2. Change the ports/settings under 'Console Access' and 'Web Interface' sections.

Thuộc tính

Hệ điều hành: Bất kỳ
Thẻ: fortiswitchauthentication
Tham chiếu: CIS FortiSwitch Benchmark v1.0.0 - 1.6.3.1 Ensure default Admin ports are changed

Kiểm tra máy này

Chạy lệnh này trên máy bạn được phép kiểm tra. Lần quét chỉ ở chế độ đọc.

shell

tmaegis scan --target fortiswitch