Ensure default Admin ports are changed

中レベル 1自動fortiswitch

説明

FortiSwitch admin ports listen on the common ports of 80 and 443. This is default behavior. While interface access is controlled by configuring network interfaces, the FortiSwitch still listens on the admin ports that have been configured, which can also cause a conflict should 80 or 443 be needed as part of additional configuration later on. FAILs if the SSH admin port is still 22 or the HTTPS admin port is still 443. Audited against FortiSwitchOS 'show full-configuration' output (standalone FortiSwitch, saved in full); patterns are scoped to the named 'config ... end' block, whose member lines are indented.

チェック方法

監査方法: 設定パターン

パターン: (?m)(?:^config system global\n(?:[ \t]+[^\n]*\n)*?[ \t]+set admin-ssh-port 22[ \t]*$|^config system web\n(?:[ \t]+[^\n]*\n)*?[ \t]+set https-port 443[ \t]*$)

修正方法

修正方法: ガイダンスまたは IaC パッチ

config system global set admin-ssh-port 4422 end config system web set https-port 4443 end # CIS guidance: CLI for changing SSH port: config system global set admin-ssh-port 4422 **(or any other uncommon port)** end CLI for changing HTTPS port: config system web set https-port 4443 **(or any other uncommon port)** end OR From Web GUI: 1. System > Admin > Settings 2. Change the ports/settings under 'Console Access' and 'Web Interface' sections.

プロパティ

オペレーティングシステム: すべて
タグ: fortiswitchauthentication
参照: CIS FortiSwitch Benchmark v1.0.0 - 1.6.3.1 Ensure default Admin ports are changed

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target fortiswitch