Ensure Maximum number of failed attempts allowed is set to 5 or fewer

CaoCấp 1Tự độngcheckpoint

Mô tả

This only takes effect if Deny access after failed attempts is enabled. The number of failed login attempts that a user is allowed before being locked out. After making that many successive failed attempts, future attempts will fail. When one login attempt succeeds, counting of failed attempts stops, and the count is reset to zero. PASS requires deny-on-fail failures-allowed of 5 or fewer. Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

Cách kiểm tra

Phương pháp kiểm tra: Mẫu cấu hình

Mẫu khớp: (?m)^set password-controls deny-on-fail failures-allowed [1-5][ \t]*$

Cách khắc phục

Phương pháp khắc phục: Hướng dẫn hoặc bản vá hạ tầng

set password-controls deny-on-fail failures-allowed 5 save config # CIS guidance: Run the following command to set the deny-on-fail failures-allowed setting. CLI: set password-controls deny-on-fail failures-allowed 5 GUI: Navigate to User Management > Password Policy > Deny Access After Failed Login Attempts: checked and set ' Maximum number of failed attempts allowed is set to' setting to 5 or fewer.

Thuộc tính

Hệ điều hành: Bất kỳ
Thẻ: checkpointhardening
Tham chiếu: CIS Check Point Firewall Benchmark v1.1.0 - 1.12 Ensure Maximum number of failed attempts allowed is set to 5 or fewer

Kiểm tra máy này

Chạy lệnh này trên máy bạn được phép kiểm tra. Lần quét chỉ ở chế độ đọc.

shell

tmaegis scan --target checkpoint