Ensure Maximum number of failed attempts allowed is set to 5 or fewer

ВысокийУровень 1Автоматическаяcheckpoint

Описание

This only takes effect if Deny access after failed attempts is enabled. The number of failed login attempts that a user is allowed before being locked out. After making that many successive failed attempts, future attempts will fail. When one login attempt succeeds, counting of failed attempts stops, and the count is reset to zero. PASS requires deny-on-fail failures-allowed of 5 or fewer. Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

Как проверяется

Метод проверки: Шаблон конфигурации

Шаблон: (?m)^set password-controls deny-on-fail failures-allowed [1-5][ \t]*$

Как исправляется

Метод исправления: Рекомендация или патч инфраструктуры

set password-controls deny-on-fail failures-allowed 5 save config # CIS guidance: Run the following command to set the deny-on-fail failures-allowed setting. CLI: set password-controls deny-on-fail failures-allowed 5 GUI: Navigate to User Management > Password Policy > Deny Access After Failed Login Attempts: checked and set ' Maximum number of failed attempts allowed is set to' setting to 5 or fewer.

Свойства

Операционные системы: Любая
Теги: checkpointhardening
Источник: CIS Check Point Firewall Benchmark v1.1.0 - 1.12 Ensure Maximum number of failed attempts allowed is set to 5 or fewer

Проверить этот хост

Выполните команду на компьютере, аудит которого вам разрешён. Сканирование работает только на чтение.

shell

tmaegis scan --target checkpoint