Database Manager Configuration Parameter: TRUST_ALLCLNTS

高等級 1人工審核db2

說明

This database manager configuration parameter is only active when the authentication parameter is set to CLIENT which is not a recommended setting as discussed in the [authentication parameter section](#specify-a-secure-authentication- type-authentication). If the parameter is set to YES, the server assumes that the client side is handling authentication to the database. If the parameter is ...

檢查方式

稽核方法: 人工審核

此項建議無法自動檢查。當您傳入 --include-manual 時，掃描結果會列出此項目並附帶這些說明。

1. Attach to the Db2 instance. db2 => attach to <db2instance> 2. Run the following command: db2 => get database manager configuration 3. Locate the AUTHENTICATION and SRVCON_AUTH values in the output. Server Connection Authentication (SRVCON_AUTH) = NOT_SPECIFIED Database manager authentication (AUTHENTICATION) = SERVER If SRVCON_AUTH does not equal CLIENT, or SRVCON_AUTH equals NOT_SPECIFIED and AUTHENTICATION does not equal CLIENT, then this is a PASS and you do not need to follow the remediation step. Otherwise one of SRVCON_AUTH or AUTHENTICATION equaled CLIENT, and the following step ...

修補方式

修補方法: 操作指南或基礎設施修補檔

1. Attach to the Db2 instance. db2 => attach to <db2instance> 2. Run the following command: db2 => update database manager configuration parameter using trust_allclnts no 3. Restart the Db2 instance. db2 => db2stop db2 => db2start

屬性

作業系統: 不限
標籤: db2databasemanual
參考資料: CIS IBM Db2 12.1 Benchmark v1.0.0 - 5.4 Database Manager Configuration Parameter: TRUST_ALLCLNTS