Ensure Reverse Path Filtering is enabled

Trung bìnhCấp 1Tự độngcos

Mô tả

Setting net.ipv4.conf.all.rp_filter and net.ipv4.conf.default.rp_filter to 1 forces the Linux kernel to utilize reverse path filtering on a received packet to determine if the packet was valid. Essentially, with reverse path filtering, if the return packet does not go out the same interface that the corresponding source packet came from, the packet is dropped (and logged if log_martians is set). Setting these flags is a good way to deter attackers from sending your system bogus packets that cannot be responded to. One instance where this feature breaks down is if asymmetrical routing is employed. This would occur when using dynamic routing protocols (bgp, ospf, etc) on your system. If you are using asymmetrical routing on your system, you will not be able to enable this feature without breaking the routing.

Cách kiểm tra

Phương pháp kiểm tra: Lệnh shell

shell

chk() { p=$1; allowed=" $2 "; case $p in net.ipv6.*) [ -d /proc/sys/net/ipv6 ] || return 0;; esac; v=$(sysctl -n "$p" 2>/dev/null) || { echo "$p: not available"; return 1; }; case "$allowed" in *" $v "*) ;; *) echo "$p is $v (running)"; return 1;; esac; sd=$(readlink -e /lib/systemd/systemd-sysctl || readlink -e /usr/lib/systemd/systemd-sysctl); f=$("$sd" --cat-config 2>/dev/null | grep -Po "^\h*${p//./\.}\h*=\h*\K\H+" | tail -n1); [ -n "$f" ] || { echo "$p is not set in any sysctl configuration file"; return 1; }; case "$allowed" in *" $f "*) ;; *) echo "$p is $f in configuration"; return 1;; esac; }; if chk net.ipv4.conf.all.rp_filter 1 && chk net.ipv4.conf.default.rp_filter 1; then echo compliant; fi

Đầu ra mong đợi: compliant

Cách khắc phục

Phương pháp khắc phục: Hướng dẫn hoặc bản vá hạ tầng

Set the following parameters in /etc/sysctl.conf or a /etc/sysctl.d/* file: net.ipv4.conf.all.rp_filter = 1 net.ipv4.conf.default.rp_filter = 1 Run the following commands to set the active kernel parameters: # sysctl -w net.ipv4.conf.all.rp_filter=1 # sysctl -w net.ipv4.conf.default.rp_filter=1 # sysctl -w net.ipv4.route.flush=1 /etc is stateless on Container-Optimized OS. Therefore, /etc cannot be used to make these changes persistent across reboots. The steps mentioned above needs to be performed after every boot.

Thuộc tính

Hệ điều hành: Bất kỳ
Thẻ: container-optimized-oscos
Tham chiếu: CIS Google Container-Optimized OS Benchmark v1.2.0 - 3.2.7 Ensure Reverse Path Filtering is enabled

Kiểm tra máy này

Chạy lệnh này trên máy bạn được phép kiểm tra. Lần quét chỉ ở chế độ đọc.

shell

tmaegis scan --target cos