Create and use a single Loopback Address for Routing Protocol Peering

DüşükDüzey 2Manuel incelemecisco-nxos

Açıklama

The use of a loopback interface is recommended for use in all routing protocols. This recommendation describes the configuration of the loopback interface. Routing protocol specific configurations are described under the respective routing protocols. Loopback interfaces are always up, and so are not dependent on physical interface link state issues (cabling or other link issues for instance). This means traffic sourced from a loopback interface can take any valid path to establish a routing relationship ... CIS assessment: Manual. Reported as SKIP with review instructions.

Nasıl denetlenir

Denetim yöntemi: Manuel inceleme

Bu öneri otomatik olarak denetlenemez. --include-manual parametresini verdiğinizde tarama bunu bu talimatlarla birlikte listeler.

CIS assessment: Manual. switch# sho ip int brief | i Lo Lo0 10.11.11.1 protocol-up/link-up/admin-up

Nasıl düzeltilir

Düzeltme yöntemi: Kılavuz veya altyapı yaması

! Creating the loopback interface is a simple process. Addressing the loopback, in particular computing the subnet mask will vary by the organization and application. Often smaller subnets can be used for loopbacks, depending on how many potential peers are possible. int loopback 0 ip address 10.11.11.1 255.255.255.252 In order to use the loopback interface (rather than the closest interface to the routing peer), it must be explicitly configured in the routing protocol. This is described in the recommendations for each respective routing protocol.

Özellikler

İşletim sistemleri: Herhangi biri
Etiketler: cisco-nxosnetworkrouting
Referans: CIS Cisco NX-OS Benchmark v1.2.0 - 3.1.4.2 Create and use a single Loopback Address for Routing Protocol Peering