TMA-CHECKPOINT-1.13

Ensure Allow access again after time is set to 300 or more seconds

OrtaDüzey 1Otomatikcheckpoint

Açıklama

Allow access again after a user has been locked out (due to failed login attempts). The user is allowed access after the configured time if there have been no login attempts during that time). This setting only takes effect if Deny access after failed login attempts is selected. PASS requires deny-on-fail allow-after of 300 seconds or more. Audited against the Gaia clish 'show configuration' output (run 'show configuration' in clish on each gateway and management server and save the full output).

Nasıl denetlenir

Denetim yöntemi: Yapılandırma deseni

Desen: (?m)^set password-controls deny-on-fail allow-after (?:[3-9]\d\d|\d{4,})[ \t]*$

Nasıl düzeltilir

Düzeltme yöntemi: Kılavuz veya altyapı yaması

set password-controls deny-on-fail allow-after 300 save config # CIS guidance: Run the following command to set the deny-on-fail allow-afte setting. CLI: set password-controls deny-on-fail allow-after 300 GUI: Navigate to User Management > Password Policy > Deny Access After Failed Login Attempts: Set the 'Allow access again after time' setting to 300 or more seconds.

Özellikler

İşletim sistemleri: Herhangi biri
Etiketler: checkpointtime
Referans: CIS Check Point Firewall Benchmark v1.1.0 - 1.13 Ensure Allow access again after time is set to 300 or more seconds

Bu ana makineyi denetle

Bunu denetleme izniniz olan bir makinede çalıştırın. Tarama salt okunurdur.

shell

tmaegis scan --target checkpoint