Control Plane ACL

ВысокийУровень 1Ручная проверкаarista-eos

Описание

A default control plane ACL is provided and applied to the system control-plane. The default control-place ACL is read-only, but you can create and assign a different ACL to the system control-plane if customization is needed. However, it is strongly recommended to use the default control-plane ACL as a template for any custom ACL that you may apply to ensure protocol and management operations function correctly. The default control plane ACL filters all IP traffic inbound and outbound on any management interface. SSH, Telnet, NTP, SNMP, IP protocols, and logging/matching on management traffic are done by this ACL. CIS assessment: Manual. Reported as SKIP with review instructions.

Как проверяется

Метод проверки: Ручная проверка

Эту рекомендацию нельзя проверить автоматически. Сканирование выводит её вместе с этими инструкциями при указании флага --include-manual.

CIS assessment: Manual. Run the following command to check that either your custom ACL or the default ACL is applied switch#show running-config all section system control-plane system control-plane ip access-group custom-control-plane-acl in ip access-group default-control-plane-acl vrf MGMT in switch# The control plane ACL is referenced by the ip[v6] access-group <ACLNAME> in configuration.

Как исправляется

Метод исправления: Рекомендация или патч инфраструктуры

! Apply a control plane ACL to the default vrf and all non default vrfs system control-plane ip access-group custom-control-plane-acl in ip access-group custom-control-plane-acl vrf MGMT in

Свойства

Операционные системы: Любая
Теги: arista-eosnetworkhardening
Источник: CIS Arista EOS Benchmark v1.0.0 - 1.1.2 Control Plane ACL