Ensure only encrypted access channels are enabled

高レベル 1自動fortiswitch

説明

Allow only HTTPS access to the GUI and SSH access to the CLI. FAILs if any interface allowaccess list contains http or telnet. Audited against FortiSwitchOS 'show full-configuration' output (standalone FortiSwitch, saved in full); patterns are scoped to the named 'config ... end' block, whose member lines are indented.

チェック方法

監査方法: 設定パターン

パターン: (?m)^config system interface\n(?:[ \t]+[^\n]*\n)*?[ \t]+set allowaccess [^\n]*\b(?:telnet|http)\b[^\n]*[ \t]*$

修正方法

修正方法: ガイダンスまたは IaC パッチ

config system interface edit "mgmt" set allowaccess https ping ssh snmp next end # CIS guidance: If HTTP or Telnet is in the allowaccess list, you will have to set that list again with the same elements except for http or telnet. On CLI: config system interface edit port1 set allowaccess ssh https ping snmp end In the web GUI, click on: 1. Network > Interfaces, select the interface and click "Edit". 2. In the interface setting page, uncheck HTTP and Telnet in the section "Administrative Access".

プロパティ

オペレーティングシステム: すべて
タグ: fortiswitchcrypto
参照: CIS FortiSwitch Benchmark v1.0.0 - 1.4.2.2 Ensure only encrypted access channels are enabled

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target fortiswitch