Disable unsecure management services on Management, SVI, or Loopback interfaces

中レベル 1自動fortiswitch

説明

Only secure management related services such as HTTPS, PING, SSH, SNMP, and RADIUS should be used on management interfaces. FAILs if any interface allowaccess list contains http or telnet. Audited against FortiSwitchOS 'show full-configuration' output (standalone FortiSwitch, saved in full); patterns are scoped to the named 'config ... end' block, whose member lines are indented.

チェック方法

監査方法: 設定パターン

パターン: (?m)^config system interface\n(?:[ \t]+[^\n]*\n)*?[ \t]+set allowaccess [^\n]*\b(?:telnet|http)\b[^\n]*[ \t]*$

修正方法

修正方法: ガイダンスまたは IaC パッチ

config system interface edit "mgmt" set allowaccess https ping ssh snmp next end # CIS guidance: On GUI: Go to "System" > "Network" > "Interface". Review the Physical, VLAN, or Loopback interface and disable HTTP and Telnet services. On CLI: config system interface edit "mgmt" set allowaccess https ping ssh snmp Note: 1. Interface name may differ based on deployment. For this example, mgmt is a switch with a dedicated management interface. Switches without a management interface this would be set to "internal".

プロパティ

オペレーティングシステム: すべて
タグ: fortiswitchmanagement
参照: CIS FortiSwitch Benchmark v1.0.0 - 1.4.2.1 Disable unsecure management services on Management, SVI, or Loopback interfaces

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target fortiswitch