Ensure 'Failover' is enabled

中レベル 1自動cisco-asa

説明

Enables failover between the security appliance and another security appliance in order to achieve high availability. Enabling failover helps to meet the availability requirement of the security CIA (Confidentiality - Integrity - Availability) triad, ensuring a physical and logical redundancy of firewalls in order to avoid service disruption should the security appliance or ... Audited against the output of 'show running-config' (run 'terminal pager 0' first; 'more system:running-config' also works and shows unmasked secrets).

チェック方法

監査方法: 設定パターン

パターン: (?m)^failover\s*$

修正方法

修正方法: ガイダンスまたは IaC パッチ

! Follow the steps below to enable active/standby failover. The commands are run in the system execution space - Step 1: For each appliance, identify the failover link physical interface <failover_interface_physical> and assign it a name <failover_interface_name> and IP address <failover_interface_ip> and subnet mask <failover_interface_mask>. Identify the other device IP address for each appliance as <peer_failover_ip> - Step 2: For each appliance, identify the state link physical interface <state_interface_physical> and assign it a name <state_interface_name> and IP address <state_interface_ip> and subnet mask <state_interface_mask>. Identify the other device IP address for each appliance as <peer_state_ip> - Step 3: Run the following on the Active device to set it as primary node failover lan unit primary - Step 4: Run the following on the Standby device to set it as secondary node failover lan unit secondary - Step 5: Run the following on both security appliances failover lan interface <failover_interface_name> <failover_interface_physical> failover interface ip <failover_interface_name> <failover_interface_ip> <failover_interface_mask> standby <peer_failover_ip> interface <failover_interface_physical> no shutdown failover link <state_interface_name> <state_interface_physical> failover interface ip <state_interface_name> <state_interface_ip> <state_interface_mask> standby <peer_state_ip> interface <state_interface_physical> no shutdown failover write memory - Step 6: Set up IPSEC preshared key failover ipsec pre-shared-key *

プロパティ

オペレーティングシステム: すべて
タグ: cisco-asanetworkhardening
参照: CIS Cisco ASA 9.x Firewall Benchmark v1.1.0 - 1.2.3 Ensure 'Failover' is enabled

このホストをチェック

監査が許可されているマシンで実行してください。スキャンは読み取り専用です。

shell

tmaegis scan --target cisco-asa