Disable SNMPv3 Query Per User

HochStufe 2Automatisiertfortiswitch

Beschreibung

Disabling SNMP query for SNMPv3 Users that only need to receive SNMP traps FAILs if any SNMPv3 user has set queries enable. Audited against FortiSwitchOS 'show full-configuration' output (standalone FortiSwitch, saved in full); patterns are scoped to the named 'config ... end' block, whose member lines are indented.

So wird geprüft

Prüfmethode: Konfigurationsmuster

Muster: (?m)^config system snmp user\n(?:[ \t]+[^\n]*\n)*?[ \t]+set queries enable[ \t]*$

So wird behoben

Behebungsmethode: Anleitung oder Infrastruktur-Patch

config system snmp user edit "<user>" set queries disable next end # CIS guidance: To disable Queries for a specific SNMPv3 User in CLI: {snmp_test is the example SNMPv3 username} config system snmp user edit snmp_test set queries disable next end To disable Queries for a specific SNMPv3 User in GUI: 1. System > Config > SNMP > Users 2. On the Users section click "Edit" on "snmp_test" and validate the configured SNMPv3 settings 3. Under the "Queries" section click the checkbox "Enabled" so it is turned off

Eigenschaften

Betriebssysteme: Beliebig
Tags: fortiswitchauthentication
Referenz: CIS FortiSwitch Benchmark v1.0.0 - 1.5.1.3 Disable SNMPv3 Query Per User

Diesen Host prüfen

Führen Sie dies auf einem Rechner aus, den Sie prüfen dürfen. Der Scan ist schreibgeschützt.

shell

tmaegis scan --target fortiswitch --level 2