Ensure NTP is enabled and IP address is set for Primary and Secondary NTP server

So wird geprüft

Prüfmethode: Konfigurationsmuster

Muster

(?m)(?:^set ntp active on[ \t]*$(?s:.*?)^set ntp server primary \S+(?s:.*?)^set ntp server secondary \S+|^set ntp active on[ \t]*$(?s:.*?)^set ntp server secondary \S+(?s:.*?)^set ntp server primary \S+|^set ntp server primary \S+(?s:.*?)^set ntp active on[ \t]*$(?s:.*?)^set ntp server secondary \S+|^set ntp server primary \S+(?s:.*?)^set ntp server secondary \S+(?s:.*?)^set ntp active on[ \t]*$|^set ntp server secondary \S+(?s:.*?)^set ntp active on[ \t]*$(?s:.*?)^set ntp server primary \S+|^set ntp server secondary \S+(?s:.*?)^set ntp server primary \S+(?s:.*?)^set ntp active on[ \t]*$)

So wird behoben

Behebungsmethode: Anleitung oder Infrastruktur-Patch

set ntp active on set ntp server primary <ntp1> version 3 set ntp server secondary <ntp2> version 3 save config # CIS guidance: Run the following command to enable the NTP and configure the Primary & Secondary NTP server. CLI: set ntp active on set ntp server primary ntpserver.time.com version 3 set ntp server primary 10.22.13.33 version 3 GUI: System Management > Time > Set Time and Date > Checked Set Time and Date automatically using Network Time Protocol (NTP) and configured the Primary NTP Server and Secondary NTP server

Diesen Host prüfen

Führen Sie dies auf einem Rechner aus, den Sie prüfen dürfen. Der Scan ist schreibgeschützt.

tmaegis scan --target checkpoint